Maker Pro
Maker Pro

Pic and JTAG Programmer

AlenZGB

Feb 19, 2014
179
Joined
Feb 19, 2014
Messages
179
It only took 5 minutes to get mine running properly when I first got it. I've had it for a very long time now.

It's all dependent on getting the right version of the software, from memory, and matching the version of the programmer firmware to the software version. I found a website giving good advice on that subject before my programmer even arrived, so I was good-to-go when it got here.

Before the K150, I used an 'Epic' parallel port programmer from 'Micro Engineering Labs' for about 10 or 15 years, but it died.

Nice, i was not think that far so i first order then spend 2 months trying to get it work
hahaha :D
 
Top