Maker Pro
Maker Pro

PIC16F876

D

Derron Roberts

Jan 1, 1970
0
I using Windows 2000 (SP4) with MPLAB 6.30 and ICD 2. I can get a program to
operate in debug mode ok, but when I switch to program mode, the device will
not run stand alone. This is on hadware which worked ok until I started to
reprogram. Any ideas welcome
 
D

Derron Roberts

Jan 1, 1970
0
Derron said:
I using Windows 2000 (SP4) with MPLAB 6.30 and ICD 2. I can get a program to
operate in debug mode ok, but when I switch to program mode, the device will
not run stand alone. This is on hadware which worked ok until I started to
reprogram. Any ideas welcome
After much investigation I found the problem.
Enabling internal pullup on RB3 and using low voltage programming causes
the above problem. So if internal pullups are required disable low
voltage programming (this is done automatically when debugging, hence it
works!)
 

Similar threads

Top