Difficult to remove because power board has those 3 cables attached. Tried inverting it to get gravity assist. Should get them off shortly to complete the test. Will let you know. Thanks.
Got both removed and tested. Left one gone and right channel one boderline according to the ESR tester, which I am not sure I trust. Ordered two replacements from DigiKey. Should be here tomorrow.
Did a retest of the newly installed Nichon 8200 mfd, 63 v caps. Measured FWB Gnd. to pin 4 =--6.62 vdc; Gnd to pin 1 = .337 vdc; across pins 2 and 3 = 4.45 vac. Doesn't make any sense. My load light is still bright. Looking at schematic and scratching my head.
Could C-1203 be bad also? Didn't do any measurements on it.