M
Mark
- Jan 1, 1970
- 0
Sorry to be a pain but after my previous post, some doubt has been
cast over whever I am talking about Plastic Injection Moulding or Not.
I am looking to have a similar product to the one shown in the
attached photo, made either here in Spain or in "China" or maybe a
combination of the two (tooling there, moulding here). I have attached
some pictures, (one by one so not to overload anybody) please could
you have a look at the item I am trying to emulate, and look at the
plastics and even more closely at the way the two parts are "welded"
together. There is a couple of the plastic parts (for example where
the mains switch is, which looks like it has been inserted into the
outer case. The plastic is not brittle but feels like some sort of
Nylon. I am totally new to plastics and would really appreciate your
positive input. If there is a better place to post this subject, then
please tell me and I will be gone, thanking you in anticipation.
Mark Scotford
[email protected] (remove the X to reply)
cast over whever I am talking about Plastic Injection Moulding or Not.
I am looking to have a similar product to the one shown in the
attached photo, made either here in Spain or in "China" or maybe a
combination of the two (tooling there, moulding here). I have attached
some pictures, (one by one so not to overload anybody) please could
you have a look at the item I am trying to emulate, and look at the
plastics and even more closely at the way the two parts are "welded"
together. There is a couple of the plastic parts (for example where
the mains switch is, which looks like it has been inserted into the
outer case. The plastic is not brittle but feels like some sort of
Nylon. I am totally new to plastics and would really appreciate your
positive input. If there is a better place to post this subject, then
please tell me and I will be gone, thanking you in anticipation.
Mark Scotford
[email protected] (remove the X to reply)