E
Eddie
- Jan 1, 1970
- 0
I am trying to make a speed switch with the LM2907. My power supply
will be 12v and I am wanting this to light up a group of lights that
will indicate to me when my wheel speed decreases below a certain
limit. I want to use a wheel speed sensor that produces a sine wave and
not a square wave. The schematic I have to go by is this.
http://img313.imageshack.us/img313/7242/speedswitch8xc.jpg
I built this with what components I had laying around. So for C I used
a 1 micro farad 50v cap. The other cap is used is a 10 micro farad 50v.
R is a 100K potentiometer. I have a resistor in series with the load
that isn't pictured and it is a 500K ohm. The other two resistor's are
both 10K. After having all this hooked up to an oscillator and a dc
power supply to provide all the inputs I need, the circuit was eratic
when I changed the oscillator output frequencies from 5 hz to 25 Khz.
For instance with the oscillator off the light would come on for 6 sec
and then go off. Turn the oscillator on and inject a signal and it
would never come on. After 2 min it would then come on and stay on.
Turn off oscillator and light would go off and stay off. Turn
oscillator on and it would still stay off even 10 min after the fact. I
am just a beginner when it comes to this stuff so please walk me
through this. The whole load being energized when Fin> 1/2C1R1. I don't
even know how to do these calculations as to when the load would
energize with the values I have already given above. Thanks for all the
help you plan on giving me.
Again.... my main goal is to have this bank of lights(4-12v lights)
illuminate when my wheel speed in my race car goes below a certain
speed. Again.......please help......
eddie
will be 12v and I am wanting this to light up a group of lights that
will indicate to me when my wheel speed decreases below a certain
limit. I want to use a wheel speed sensor that produces a sine wave and
not a square wave. The schematic I have to go by is this.
http://img313.imageshack.us/img313/7242/speedswitch8xc.jpg
I built this with what components I had laying around. So for C I used
a 1 micro farad 50v cap. The other cap is used is a 10 micro farad 50v.
R is a 100K potentiometer. I have a resistor in series with the load
that isn't pictured and it is a 500K ohm. The other two resistor's are
both 10K. After having all this hooked up to an oscillator and a dc
power supply to provide all the inputs I need, the circuit was eratic
when I changed the oscillator output frequencies from 5 hz to 25 Khz.
For instance with the oscillator off the light would come on for 6 sec
and then go off. Turn the oscillator on and inject a signal and it
would never come on. After 2 min it would then come on and stay on.
Turn off oscillator and light would go off and stay off. Turn
oscillator on and it would still stay off even 10 min after the fact. I
am just a beginner when it comes to this stuff so please walk me
through this. The whole load being energized when Fin> 1/2C1R1. I don't
even know how to do these calculations as to when the load would
energize with the values I have already given above. Thanks for all the
help you plan on giving me.
Again.... my main goal is to have this bank of lights(4-12v lights)
illuminate when my wheel speed in my race car goes below a certain
speed. Again.......please help......
eddie