Maker Pro
Maker Pro

Problem regarding DFU/RESET switch not working.

vedant jani

May 17, 2022
2
Joined
May 17, 2022
Messages
2
I am using STmicrocontroller's controller and I am facing problem of DFU/RESET Switch that after booting the controller by reset pin the DFU mode is not detect.

what is the possible solution of this?
 

kellys_eye

Jun 25, 2010
6,514
Joined
Jun 25, 2010
Messages
6,514
What are you 'doing' with the reset pin? Is it a pull-up or pull-down input? Are you using a switch (i.e. pushbutton) or an electrical signal?
 

vedant jani

May 17, 2022
2
Joined
May 17, 2022
Messages
2
yes i am using a reset switch. so after applying boot mode the controller can reset. Its also using USB protocol only.
 
Top