Maker Pro
Maker Pro

Quality Rubber Belts Source

Hi,

I have an Aiwa Z-L500 stereo in my living room that I had
worked on more than once for the same problem, replacing the rubber belts
on the cassette units. The last time I replaced those belts, the problem
came back in less than two years.

Note: I have been doing service work for years.

I am willing to pay much more for quality rubber belts, but I don't know
a source. Do you know a source for quality belts?

Thank You in Advance, John

PS, Remove "ine" from my email address
 
N

N_Cook

Jan 1, 1970
0
Hi,

I have an Aiwa Z-L500 stereo in my living room that I had
worked on more than once for the same problem, replacing the rubber belts
on the cassette units. The last time I replaced those belts, the problem
came back in less than two years.

Note: I have been doing service work for years.

I am willing to pay much more for quality rubber belts, but I don't know
a source. Do you know a source for quality belts?

Thank You in Advance, John

PS, Remove "ine" from my email address



Replacement ones are likely contemporary with the machines so equally
perished. Make your own from bike/motorcycle/car tyre inner tube or silicone
kitchen bake ware and a "bean slicer" if too thick. Maybe purple or orange
and you have to allow for more stretch if silicone rubber but who will be
looking in there
 
N

N_Cook

Jan 1, 1970
0
Arfa Daily said:
Cassette belts are becoming much rarer. Every time I need to restock my
supplies, it's getting harder to find some sizes. There are still places on
eBay where you can get them, as well as some trade suppliers here in the UK,
but they tend to come in 'mixed bags' of sizes now, rather than being able
to order a pack of five of this size and five of that size. As to quality,
they are what they are. Over many years, I've not found a lot of difference
amongst suppliers' offerings, to be honest.

Being a bit more specific on your requirements, most Aiwa parts are still
available, but since Sony bought them out, it's now they that supply them.

Arfa


In packs where the plasticizer of the belts has reacted with the plasticizer
of the wrapping plastic, leaving a tell-tale brown staining in the bag - ie
as old and therefore suspect as the broken belts in the machines.
Often with the job-lot ones you can see the original moulding lines on one
side of the
innertubes that they derive from. May as well do the same yourself and then
you can 'source ' any size at any time. Wide or square belts easy-peasy . If
the original was round, ie extruded rather than cut , I've never found a
problem with a square section replacement as long as there is no twist in
the run.
 
N

N_Cook

Jan 1, 1970
0
Just found an excellent source material for cassette bands -Maru slicone
swimcaps, for swimmers
So cutting sections of a spherical surface in effect
If 30 degree toe-in angle is ok with bulbous pulleys then , for the .4mm
thick rubber and 6mm wide cut strips diameter of 40mm (with toe-in angle of
30 degrees)
up to 70 mm diameter with zero degree toe-in angle (sphere diameter) range.
Silicone is about 50 percent more elongation for given load , area for area
, than normal rubber.
That is for the one in front of me, probably different sizes available from
babies upwards.
 
Top