Maker Pro
Maker Pro

Radionics D5200 Programmer

Optionidus

Mar 4, 2018
2
Joined
Mar 4, 2018
Messages
2
Looking for someone who has knowledge of working with a Radionics D5200 Programmer. I just purchased a used one that has passwords that I need to have defaulted. Any suggestions?
 

ChosunOne

Jun 20, 2010
480
Joined
Jun 20, 2010
Messages
480
The last time I worked with one of those was about 25 years ago, and I'm pretty sure I never had occasion to change its password. I seem to remember those programmers were designed to enforce a "vendor lock-out", i.e., keep one vendor from poaching another vendor's accounts/systems. Radionics in that era was not just not-friendly to DIYers, it was downright hostile. The passwords were used to keep out unauthorized professional techs, (as well as tech-savvy DIYers) so I suspect changing or deleting it is difficult if not impossible.

However, as I implied, I haven't worked with Radionics (now owned by Bosch) for 25ish years, so you might find a more optimistic reply at this site, where current Bosch/Radionics techs frequent:

http://www.shieldlab.com/forum/index.php/board,80.0.html
 
Top