Maker Pro
Maker Pro

Relay testing

ayekaybee

Nov 28, 2014
7
Joined
Nov 28, 2014
Messages
7
hello all,

Can anyone help me out in trying to figure out how to test a S60D125 relay? I'm not sure what I should be reading on which points, how much voltage and amps to apply to which points, etc. Any help is greatly appreciated!
 

Ylli

Jun 19, 2018
371
Joined
Jun 19, 2018
Messages
371
Data sheet here: https://www.mouser.com/datasheet/2/404/s-13904.pdf

No simple way to test it. You could apply an input to the 'coil' of the rated 7 - 30 volts and be sure it draws a little current. May be as low as 1 mA. The output side, you will need to provide an AC voltage and a load, then see if it switches.
 

ayekaybee

Nov 28, 2014
7
Joined
Nov 28, 2014
Messages
7
So there needs to be an AC input into the output side? Also, what sort of load?
 

Ylli

Jun 19, 2018
371
Joined
Jun 19, 2018
Messages
371
A 24 VAC source and a 24v lamp would be the safest. Higher AC voltages with an appropriate load are OK, but be carefull.
 
Top