Maker Pro
Maker Pro

Repair trigger switch

zcomputer5

Jul 20, 2011
1
Joined
Jul 20, 2011
Messages
1
Hello everyone this is my first post. Today I was trying to put a new long electrical cable on my sander because the old one was too short but my mistake I took apart the trigger switch, I was wondering can trigger switched be put back together again? I can't seem to figure out how to put it back together again. Here are a few pictures.
 

Attachments

  • 2011-07-20 18.17.34.jpg
    2011-07-20 18.17.34.jpg
    20.8 KB · Views: 163
Top