Maker Pro
Maker Pro

Repairing QPAD QH-90 Headset

Nocure

Jan 14, 2016
3
Joined
Jan 14, 2016
Messages
3
Hi, so I have a QPAD QH-90 gaming headset that I am trying to repair. From the headset is a cable that then splits into a TRS plug for audio, and one for the microphone. The cable for the microphone broke behind the plug, so I was going to solder on a new plug. But the wires inside doesn't look like they usually do. There are two different colors of copper wire that were twisted around each other. One is red, and one is copper colored, and there's some fuzz too.

My question is which goes where on a TRS plug?
 

Attachments

  • 20160114_141315__1452778127_82.209.159.171.jpg
    20160114_141315__1452778127_82.209.159.171.jpg
    10.8 KB · Views: 296
  • 20160114_141449__1452778160_82.209.159.171.jpg
    20160114_141449__1452778160_82.209.159.171.jpg
    7.8 KB · Views: 319

dorke

Jun 20, 2015
2,342
Joined
Jun 20, 2015
Messages
2,342
The fuzz is of no importance remove/cut it .
The bare wire(s) are shield/GND.

So,How many insulated wires are you left with, one red and one white ?
 
Last edited:

dorke

Jun 20, 2015
2,342
Joined
Jun 20, 2015
Messages
2,342
If there is just on internal insulated wire.
Connect like shown:

20160114_141449__1452778160_82.209.159.171.jpg
 

Nocure

Jan 14, 2016
3
Joined
Jan 14, 2016
Messages
3
So the red colored copper wire on signal then, and the copper colored one on shield?
 
Top