Maker Pro
Maker Pro

REQ: Info on old electronic industrial balancer

M

Matt J. McCullar

Jan 1, 1970
0
Got a 1950's-era Electronic Industrial Balancer, made by Stewart Warner, but
have no documentation. It's a vacuum-tube rig and I'm trying to
troubleshoot it, but without a schematic it's a bit difficult for a tech
like me. I telephoned the Stewart Warner company, but their tech support
told me that the branch of their company that handled industrial gauges and
such was sold off decades ago and they have no documentation left.

Here's the data from the nameplate:

Stewart Warner
Electronic Industrial Balancer
Model #329108


Thanks muchly!

Matt J. McCullar
 
M

Michael A. Terrell

Jan 1, 1970
0
Matt J. McCullar said:
Got a 1950's-era Electronic Industrial Balancer, made by Stewart Warner, but
have no documentation. It's a vacuum-tube rig and I'm trying to
troubleshoot it, but without a schematic it's a bit difficult for a tech
like me. I telephoned the Stewart Warner company, but their tech support
told me that the branch of their company that handled industrial gauges and
such was sold off decades ago and they have no documentation left.

Here's the data from the nameplate:

Stewart Warner
Electronic Industrial Balancer
Model #329108

Thanks muchly!

Matt J. McCullar


If its tube, and 50 years old it's likely full of paper capacitors
that develop leakage, over time. That causes too much current to flow
through the tubes, and can also cause resistors to overheat and change
value, or open completely.


--
Service to my country? Been there, Done that, and I've got my DD214 to
prove it.
Member of DAV #85.

Michael A. Terrell
Central Florida
 
Top