Maker Pro
Maker Pro

SMD broken

stepsan

Dec 12, 2012
4
Joined
Dec 12, 2012
Messages
4

(*steve*)

¡sǝpodᴉʇuɐ ǝɥʇ ɹɐǝɥd
Moderator
Jan 21, 2010
25,510
Joined
Jan 21, 2010
Messages
25,510
I'd say it is a transistor or mosfet that has been damaged by hear (overload essentially)

Can you read what it has printed on top of it? The best I can make out it is 0100.
 

stepsan

Dec 12, 2012
4
Joined
Dec 12, 2012
Messages
4
It has printed 010D as much as I can read. What do you suggest I can replace with?
 

(*steve*)

¡sǝpodᴉʇuɐ ǝɥʇ ɹɐǝɥd
Moderator
Jan 21, 2010
25,510
Joined
Jan 21, 2010
Messages
25,510
My cross-reference guide does not list a part marked 010D

Maybe we can figure out what the device is by inspection... Anyone?

(We'll probably need good close-up images of both sides of the board though).

edit: Are there any other components with the same markings?
 

stepsan

Dec 12, 2012
4
Joined
Dec 12, 2012
Messages
4
There is another identical component that you can see in the photos. I have changed the burnt one with the other and now the circuit works correctly. I still don't know what component is. Thanks in any case.
 

(*steve*)

¡sǝpodᴉʇuɐ ǝɥʇ ɹɐǝɥd
Moderator
Jan 21, 2010
25,510
Joined
Jan 21, 2010
Messages
25,510
OK, the whole point of asking is there is another similar component is so we (you) can do measurements and determine what it is.

If this one fails too, where are you?

Also, by removing this transistor you have disabled some functionality and I can't tell what that is.
 

stepsan

Dec 12, 2012
4
Joined
Dec 12, 2012
Messages
4
OK, the whole point of asking is there is another similar component is so we (you) can do measurements and determine what it is.

If this one fails too, where are you?

Also, by removing this transistor you have disabled some functionality and I can't tell what that is.

Sorry for delay. What kind of test can I do to determine what it is?
I have a multimeter and an oscilloscope to check it.

The faulty chip is related with the charge of the batteries.
 

(*steve*)

¡sǝpodᴉʇuɐ ǝɥʇ ɹɐǝɥd
Moderator
Jan 21, 2010
25,510
Joined
Jan 21, 2010
Messages
25,510
You need to use your multimeter to measure between all the pins of the device (6 measurements because you do it both ways) while it is out of the circuit.

From that we may be able to tell what the function is. We might be able to guess at a device you can try to replace it with.

We'll also need to know what the device is, the voltage it runs from, and the current that high intensity LED draws.
 
Top