R
[email protected]
- Jan 1, 1970
- 0
Hi, I'd like to preface this post by saying I know alot about software
and little about electronics. Please speak slowly and use small words.
I salvaged a stepper motor for a project I'm working on (it says Epson
Precision(H.K.) LTD. 8310 770173) and I would like to be able to
control this motor via my parallel port. All I know is that it has 6
wires, 2 are the same color, and I probably need some sort of hardware
between the parallel port and the motor.
I've been to http://www.doc.ic.ac.uk/~ih/doc/stepper/ but it's a little
over my head. Any suggestions for where I should start on this project?
and little about electronics. Please speak slowly and use small words.
I salvaged a stepper motor for a project I'm working on (it says Epson
Precision(H.K.) LTD. 8310 770173) and I would like to be able to
control this motor via my parallel port. All I know is that it has 6
wires, 2 are the same color, and I probably need some sort of hardware
between the parallel port and the motor.
I've been to http://www.doc.ic.ac.uk/~ih/doc/stepper/ but it's a little
over my head. Any suggestions for where I should start on this project?