Maker Pro
Maker Pro

Suggestions on molded , shielded, cabling system

Q

qu1nn

Jan 1, 1970
0
Hello,

Does anyone have suggestions supplier of cable assemblies that would
meet the following requirements:

4 conductor, small overall diameter (<0.25"), 20-24AWG stranded
Shielded
IP 67
right angle circular connector one end, wire the other end.
~ 1.5m length,



I was looking at the lumberg RKMWV series.
Just looking for alternatives.

Thank you for your time
qu1nn
 
S

Sporkman

Jan 1, 1970
0
qu1nn said:
Does anyone have suggestions supplier of cable assemblies that would
meet the following requirements:

4 conductor, small overall diameter (<0.25"), 20-24AWG stranded
Shielded
IP 67
right angle circular connector one end, wire the other end.
~ 1.5m length,

You need a harness maker with overmolding capabilities. It has been a
long time since I used such services, but I remember one with whom I had
good results and good cooperation. They were CEA Technologies, Inc
located in Colorado Springs (www.ceatechnologies.com). I have no
current business relationship with them and no vested interest either.

Mark 'Sporky' Stapleton
Watermark Design, LLC
www.h2omarkdesign.com
 
Q

qu1nn

Jan 1, 1970
0
Hello,

Does anyone have suggestions supplier of cable assemblies that would
meet the following requirements:

4 conductor, small overall diameter (<0.25"), 20-24AWG stranded
Shielded
IP 67
right angle circular connector one end, wire the other end.
~ 1.5m length,



I was looking at the lumberg RKMWV series.
Just looking for alternatives.

Thank you for your time
qu1nn

Scrap the 4 conductor I need 7 conductor, the overall dia can increase a bit
 
Top