Kenneth Tan
- May 22, 2015
- 58
- Joined
- May 22, 2015
- Messages
- 58
I would appreciate some pointers to get me started.
I have build a led light for my photography.
It uses a 2P4S lipo battery setup.
I also have pcb's to charge lipo's controlled.
I would like to build an electronic switch so I could change between load and charging these battery pairs.
It can be done with a multi pole mechanical switch, but I'm looking if there's an electronic solution to switch between these two circuits.
I'll post a schematic of the setup later today. Can't do this on my phone.
Any help will be greatly appreciated.
I have build a led light for my photography.
It uses a 2P4S lipo battery setup.
I also have pcb's to charge lipo's controlled.
I would like to build an electronic switch so I could change between load and charging these battery pairs.
It can be done with a multi pole mechanical switch, but I'm looking if there's an electronic solution to switch between these two circuits.
I'll post a schematic of the setup later today. Can't do this on my phone.
Any help will be greatly appreciated.