Maker Pro
Maker Pro

Tektronix 2235 Sweep Generator (horizontal mode) A issue

JRUBIN

Jul 17, 2015
96
Joined
Jul 17, 2015
Messages
96
OOOPS!

I started a post and then forgot to copy in the rest. As I stated, I started working back from Section 6. Test point [30] is just before R740 In checking all 3 connections of this resistor I saw that the garbled signal was only seen on the side facing R741. Id visited this pot before two weeks ago, it cleared up after agitation, but came back. This time before attempting replacement, i hit it with deoxit and then worked it, no problems for several days since.
 

JRUBIN

Jul 17, 2015
96
Joined
Jul 17, 2015
Messages
96
I continue right where we left off with the first of 7 movies that contain the repair and calibration of this unit. A long awaited closure of this project going back to 2015


 
Top