Maker Pro
Maker Pro

Temp sensor and PWM for 12v fan-2 wire or 4 wire?

wopachop

Jul 22, 2012
47
Joined
Jul 22, 2012
Messages
47
I feel like the error has to be something im doing wrong.
All 4 switches have a working LED. I hear the relay click when i adjust the temp up and down.
But for some reason the output doesnt seem to work.
 

Attachments

  • 20180717_081105.jpg
    20180717_081105.jpg
    260 KB · Views: 21

dave9

Mar 5, 2017
1,188
Joined
Mar 5, 2017
Messages
1,188
A voltage measurement would be between K0 and ground or K1 and ground, not between K0 and K1.

Similarly your powered load (fans or LEDs, etc) is connected to K0 and ground.
 
Last edited:

wopachop

Jul 22, 2012
47
Joined
Jul 22, 2012
Messages
47
Ok cool thats what i thought you were saying yesterday. K0 and K1 never get hot when the meter is grounded to the 12v input ground.

Also the center pin is never hot and you were saying it should always show 12v.
 

wopachop

Jul 22, 2012
47
Joined
Jul 22, 2012
Messages
47
Thanks again for the help and teaching me how it works. With these pics is it safe to say something is broken inside the relay? Even though i hear all 4 of the click?20180717_111227.jpg 20180717_111238.jpg
 

dave9

Mar 5, 2017
1,188
Joined
Mar 5, 2017
Messages
1,188
I am in disbelief that all 4 are broken, but if you have tested them appropriately then that seems to be the case.

I would take a day off, think about something else for a while then come back at this with a fresh mind starting over.
 
Last edited:
Top