Maker Pro
Maker Pro

Thomson ICC17

S

Seafarer

Jan 1, 1970
0
After I retired I rid myself of all gear and notes now my own TV is
tripping.It trips off then straight back on again.Sometimes it trips
off with the sequence flasing 7 then 2 flashes.As expected I've lost
the code for these sequences.
I will go into the service mode shortly and I'm not looking forward to
it as it is a dual switch mode power supply,one for s/by.
Before I do anyone know the code flashes instructions?
I do have the service sheet for this but not the manual and the fault
flashes are not listed. Thanks


"Too soon we get Old,Too late we get Smart".
 
S

Seafarer

Jan 1, 1970
0
After I retired I rid myself of all gear and notes now my own TV is
tripping.It trips off then straight back on again.Sometimes it trips
off with the sequence flasing 7 then 2 flashes.As expected I've lost
the code for these sequences.
I will go into the service mode shortly and I'm not looking forward to
it as it is a dual switch mode power supply,one for s/by.
Before I do anyone know the code flashes instructions?
I do have the service sheet for this but not the manual and the fault
flashes are not listed. Thanks


"Too soon we get Old,Too late we get Smart".
No replies but no matter,I've downloaded the full specs from Google
including service sheet with waveforms[my own service sheet did not
have these] it's a lot easier when the wave forms and chip voltages
are included.


"Too soon we get Old,Too late we get Smart".
 

Similar threads

Top