J
Jamie Morken
- Jan 1, 1970
- 0
Hi,
I am trying to pick out gate drive transformers for a 600Volt SMPS,
and am wondering what the required clearances are between PCB pads
for the transformer primary to secondary for this to meet UL
requirements for 600Volts operation. I remember reading 0.1" for
500Volts was enough, but I've also read 8mm (0.31") somewhere.
Anyone have experience on this?
cheers,
Jamie
I am trying to pick out gate drive transformers for a 600Volt SMPS,
and am wondering what the required clearances are between PCB pads
for the transformer primary to secondary for this to meet UL
requirements for 600Volts operation. I remember reading 0.1" for
500Volts was enough, but I've also read 8mm (0.31") somewhere.
Anyone have experience on this?
cheers,
Jamie