Maker Pro
Maker Pro

Using induction clamp to see ignition voltage spikes and DC current?

  • Thread starter Ricky Spartacus
  • Start date
R

Ricky Spartacus

Jan 1, 1970
0
I`m trying to display ignition voltages and DC currents on my o`scope.
I`ll be clamping the timing gun`s induction clamp onto one of the
ignition plug wires and hook the other end of the induction wires to
an o`scope. I am hoping to see a voltage jump of some sort. Will this
work? And If I later clamp it around an alternator cable, being under
load, will I see at least 30A of DC currents?
TIA
Ricky
 
N

Neil Nelson

Jan 1, 1970
0
I`m trying to display ignition voltages and DC currents on my o`scope.
I`ll be clamping the timing gun`s induction clamp onto one of the
ignition plug wires and hook the other end of the induction wires to
an o`scope. I am hoping to see a voltage jump of some sort. Will this
work?

I doubt it, but experiment anyway.
Generally, if you want to see anything useful with any level of
resolution, you need a capacitive pick-up to view an ignition
waveform. Your #1 inductive clamp should work as a trigger
though.
And If I later clamp it around an alternator cable, being under
load, will I see at least 30A of DC currents?

Nope, you'll need a hall effect inductive clamp to measure
current.
 
J

Jim

Jan 1, 1970
0
Ricky said:
I`m trying to display ignition voltages and DC currents on my o`scope.
I`ll be clamping the timing gun`s induction clamp onto one of the
ignition plug wires and hook the other end of the induction wires to
an o`scope. I am hoping to see a voltage jump of some sort. Will this
work? And If I later clamp it around an alternator cable, being under
load, will I see at least 30A of DC currents?
TIA
Ricky

You can see the plugs firing with just a couple loops around the plug
wires. You won't see much on the alternator as it's damped by the battery.
 
M

Mike Walsh

Jan 1, 1970
0
An inductive clamp will sense changes in the magnetic field produced by an electric current and can't be used for DC.
 
Top