Maker Pro
Maker Pro

Wheelchair motor

Frank3point14

Sep 6, 2013
10
Joined
Sep 6, 2013
Messages
10
Hello..!!!!
I am Electronic Hobbyist...
I'm working on Electric Wheel Chair.....
I'm confused about Motor(Which DC/AC motor should i choose) and as i want to implement it with cost efficiently is there any idea about low cost Joy stick..

Thank YOU !!!!!
 

Frank3point14

Sep 6, 2013
10
Joined
Sep 6, 2013
Messages
10
I 've a question that is this joystick is compatible to PIC18FXXXX......????
CUZ i want to use PIC..!!!!

Is this possible....!!!!Any idea...
 
Last edited:

conductor3

Jun 7, 2011
84
Joined
Jun 7, 2011
Messages
84
the only thing i can tell you is that the on i showed you has 5 pins (VCC, GND, X, Y and sw) vcc goes to positive and gnd goes to negative x,and y are anolog outputs for the x and y axis and sw is a digital out for the push button the two pis on the board labled r5 is for a resistor (pull down) but they dont come with it so you need to add one if your going to us it (it will ruin a microcontroller if not put there)
 
Last edited:

conductor3

Jun 7, 2011
84
Joined
Jun 7, 2011
Messages
84
so all you need is a microcontroller with positve and negative and 2 anolog inputs toread a variable between positive and negetive (there is 2 potentiometers on it onefor each axis)
 

conductor3

Jun 7, 2011
84
Joined
Jun 7, 2011
Messages
84
and the moter will be dc other wise you wont be able to go backwards
 
Last edited:
Top