Hi all,
So a while ago my little Korg monotron's output jack stopped functioning properly. But, I figured that since the built-in speaker still works, and I like the sounds that that cheap little speaker can make, I could wire a mono jack in parallel with the speaker.
My question to you is is there anything special to consider when doing this (adding resistors, etc.)? If I can't wire a jack in parallel, I could measure the response of the speaker and set up an EQ to match it, so it's not a huge issue if I can't do it.
So a while ago my little Korg monotron's output jack stopped functioning properly. But, I figured that since the built-in speaker still works, and I like the sounds that that cheap little speaker can make, I could wire a mono jack in parallel with the speaker.
My question to you is is there anything special to consider when doing this (adding resistors, etc.)? If I can't wire a jack in parallel, I could measure the response of the speaker and set up an EQ to match it, so it's not a huge issue if I can't do it.