Can anyone identify this connector on an Ultimaker 2+ ?

[RobertPhoenix]

One of the connectors has obviously been getting too hot, and maybe being flexed, because the wires just dropped off when I examined it. I'm attaching pictures of the board showing the male part attached to the PCB, and also the female floating part.

I'm like to get the part number/manufacturer so that I can get replacements from somewhere like DigiKey or Mouser.

 

[Martaine2005]

Hi Robert, I doubt you would find the exact connectors but JST have similar looking connectors.
Do an image search for JST PCB mount connectors.
You will need to know the pin pitch if you only want one connector. May be simpler and cheaper to just replace it with similar?.

Martin

 

[Delta Prime]

Here you go buddy have fun.

Support Community

support.makerbot.com

 

[RobertPhoenix]

Hi Robert, I doubt you would find the exact connectors but JST have similar looking connectors.
Do an image search for JST PCB mount connectors.
You will need to know the pin pitch if you only want one connector. May be simpler and cheaper to just replace it with similar?.

Martin

Many thanks. I think I have now located these on Amazon. I'll know by tomorrow if they work !

 

[RobertPhoenix]

Here you go buddy have fun.

Support Community

support.makerbot.com

Thanks. Unfortunately they only way to get the connector is to buy it with the stepper motor attached ! I think I have found the right connectors at Amazon

https://a.co/d/6HIvIwC

 

[Delta Prime]

I think I have found the right connectors

Well of course you did, @Martaine2005 is among the best IMHO.

Unfortunately they only way to get the connector is to buy it with the stepper motor attached !

Apologies, I should have
scrupulously researched your request. My bad.