I would like to retro-fit my tail lamp assemblies with LEDs. I am not looking to do sequential tail lamps or anything like that.
I have a typical GM setup two dual filament bulbs in each assembly. Here are the schematics for reference.
I am confident in picking a resistor size and how I will wire up the LEDs in the array. What puzzles me is how do I get the LEDs to have two intensities? One for tail lamps and two for brakes. Also how is this going to work for turn signals?
I would like to wire up two round PCBs in each assembly. The assembly looks as such:
PCB on the inside would be slightly larger than the outside.
See nothing crazy. I searched the net but I found no conclusive DIY projects with details. I apologize if this has been discussed before. Thanks in advance!
I have a typical GM setup two dual filament bulbs in each assembly. Here are the schematics for reference.
![2cfp0za.jpg](/forums/proxy.php?image=http%3A%2F%2Fi49.tinypic.com%2F2cfp0za.jpg&hash=88e61c58314c67a525fb35e088afc014)
![2ijsxo8.jpg](/forums/proxy.php?image=http%3A%2F%2Fi46.tinypic.com%2F2ijsxo8.jpg&hash=8369ac4ce5810c2af38bc7fc20e27a75)
![262o3z9.jpg](/forums/proxy.php?image=http%3A%2F%2Fi48.tinypic.com%2F262o3z9.jpg&hash=fd8b5bdf7fa6ad166fbc3c92066144f9)
I am confident in picking a resistor size and how I will wire up the LEDs in the array. What puzzles me is how do I get the LEDs to have two intensities? One for tail lamps and two for brakes. Also how is this going to work for turn signals?
I would like to wire up two round PCBs in each assembly. The assembly looks as such:
![ngpnrm.jpg](/forums/proxy.php?image=http%3A%2F%2Fi46.tinypic.com%2Fngpnrm.jpg&hash=ad23f6f8933bc2234648435a870a5c2a)
PCB on the inside would be slightly larger than the outside.
See nothing crazy. I searched the net but I found no conclusive DIY projects with details. I apologize if this has been discussed before. Thanks in advance!