Darrin said:
I am looking for a small-scale PCB maker in and around Sydney for a few
prototype boards? Any help appreciated.
Well I was holding out on replying to this Post until I got some PCBs back
......
Sesame Electronics (
http://members.tripod.com/~sesame_elec/ ) Offer
Prototyping services
This is based on a panel size of 150*250 mm which will cost approx $100 for
this you get the PCb etched and Drilled (appears to be by hand and they
offer cheaper for undrilled boards) they have experimented in the past with
various tinning techniques (unsuccessfully) but now just leave the resist on
the PCB which can be cleaned off with Metho.
I have just received 2 of their 'Fully Featured boards' which are single
sided 150*110 mm these cost me $160 total and include : Drilling, Solder
tinning, Overlay, Solder mask and I have to say they are a superb job.
The prices for these boards in bulk drops quite steeply I asked for an idea
of how much extra boards would have cost (At this stage my order was for
Prototypes and to see what standard these PCBs were up to)
10 extra would cost another $164
20 extra would cost another $255
50 extra would cost another $379
Regards
Richard Freeman
