J
James Sweet
- Jan 1, 1970
- 0
I was thinking there might be a more appropriate place for this but I
haven't found one yet. Anyhow I recently aquired a hot tub with an Aqua-flo
FloMaster XP 4.5 HP pump which came to me partially disasembled and missing
a few bits. I had first thought I'd just buy a whole new pump but after
realizing they're close to $400 I decided to take a shot at rebuilding this
one. Before I break it, does anyone know how to remove the impeller? Does it
just pull off the shaft, or is it threaded, and if so which direction is the
thread? I know I need to get that off since the shaft seal is shot, the
start and run caps are also missing but the windings pass the visual
inspection and ohm meter check and the bearings feel ok which leads me to
believe there's a good chance this thing will be fine with a bit of effort.
Unfortunatly there doesn't seem to be much info on this particular pump
online.
haven't found one yet. Anyhow I recently aquired a hot tub with an Aqua-flo
FloMaster XP 4.5 HP pump which came to me partially disasembled and missing
a few bits. I had first thought I'd just buy a whole new pump but after
realizing they're close to $400 I decided to take a shot at rebuilding this
one. Before I break it, does anyone know how to remove the impeller? Does it
just pull off the shaft, or is it threaded, and if so which direction is the
thread? I know I need to get that off since the shaft seal is shot, the
start and run caps are also missing but the windings pass the visual
inspection and ohm meter check and the bearings feel ok which leads me to
believe there's a good chance this thing will be fine with a bit of effort.
Unfortunatly there doesn't seem to be much info on this particular pump
online.
