Win the Arduino GIGA Display Shield Bundle — the GIGA R1 WiFi board (ABX00063) paired with the GIGA Display Shield (ASX00039). A dual-core STM32H7 board with 76 GPIOs and Wi-Fi/Bluetooth, plus a 3.97" capacitive touchscreen with onboard IMU, mic, and RGB LED. Everything you need to build a project with a real user interface.
This bundle pairs two of Arduino's most capable boards into a single package for anyone building projects that need serious processing power and a proper front end. The GIGA R1 WiFi is built around the STM32H747XI, a dual-core MCU running an Arm Cortex-M7 at 480 MHz alongside a Cortex-M4 at 240 MHz, with a full DSP instruction set and memory protection unit. It carries 2 MB of flash and 1 MB of RAM on-chip, backed by 16 MB of QSPI NOR flash and 8 MB of SDRAM. Connectivity comes from a Murata 1DX module handling Wi-Fi 802.11b/g/n and Bluetooth Low Energy, with a micro UFL connector if you want an external antenna. On the I/O side you get 76 digital pins, 12 analog inputs, two DACs, 13 PWM channels, USB-C for programming and HID, USB-A host for keyboards and mass storage, and an ATECC608A secure element — all in the familiar Mega/Due form factor, so your existing shields and enclosures still fit.
The GIGA Display Shield drops straight onto the board and turns it into a self-contained interactive device. It brings a 3.97" TFT panel at 480×800 with 16.7 million colors and a capacitive touch sensor supporting five-point multitouch and gestures. Beyond the screen, the shield packs a BMI270 six-axis IMU, an MP34DT06J omnidirectional digital microphone, and an RGB LED with a dedicated driver — enough sensing to build a voice assistant, a motion-controlled interface, or a 3D printer control panel without adding a single external component. Between the two, this is a natural fit for HMI work, robotics, data acquisition, audio and signal processing, or just prototyping an interaction design idea quickly. Enter below for your chance to win.
