buildingdoc
- Apr 16, 2011
- 1
- Joined
- Apr 16, 2011
- Messages
- 1
I am trying to drive a relay with my motorcycles "soft-on/off" headlamp circuit, this is causing the relay to chatter when going on and off. I am thinking it is a sawtooth 12 Volt pulse, which I measured at 50 HZ on my frequency scale on my multimeter. I am thinking with the right Capacitor I should be able filter the ripple for the 2 seconds that the output is ramping up. this system works by suppling 12V+ to the bulb common and varying the ground potential to the high and low beam filaments.
Any help would be greatly appreciated
Bob
Any help would be greatly appreciated
Bob