N
N_Cook
- Jan 1, 1970
- 0
For small motors
I've determined a way of making flat or square section drive bands so know
the elongation characteristic of the band for a given cross-section , and
the unstretched length for a requiremnent, but not the required tension in
the band (originals missing) and hence calculated unstretched circumference.
Is there a table of tension v band dimensions v motor type?
eg size of motor and whether low speed ,say 3/4 inch diam pinion or high
speed and 1/4 or so pinions.
Or will I have to get inside a few cassette deck/vcr/vinyl decks , measure
and construct a table.
I've determined a way of making flat or square section drive bands so know
the elongation characteristic of the band for a given cross-section , and
the unstretched length for a requiremnent, but not the required tension in
the band (originals missing) and hence calculated unstretched circumference.
Is there a table of tension v band dimensions v motor type?
eg size of motor and whether low speed ,say 3/4 inch diam pinion or high
speed and 1/4 or so pinions.
Or will I have to get inside a few cassette deck/vcr/vinyl decks , measure
and construct a table.