Hi all.
A while ago i bought a cheap second 32" plasma. It used to turn on then Fter 5 mins or so the buttons stop working so if u turned it off you would have to wait a few hours for it to come on again. Then it started to not turn on and would eventually after two or three tries. Now nothing. It also had something wrong with red if there was a still image of red it shaked a little bit.
I i have pulled the tv apart. And i think i have found the start of the problem. In the attached photo the top left of the power board there is a cable running to the green board in the middle. The standby voltage should be 5v but is abiut 3v. If i disconnect this cable so the green board isnt connected i have the 5v back. So does this mean the faults in the green board or is it one of those misleqding things that its still in the power board.
Any help would be appreciqted.
A while ago i bought a cheap second 32" plasma. It used to turn on then Fter 5 mins or so the buttons stop working so if u turned it off you would have to wait a few hours for it to come on again. Then it started to not turn on and would eventually after two or three tries. Now nothing. It also had something wrong with red if there was a still image of red it shaked a little bit.
I i have pulled the tv apart. And i think i have found the start of the problem. In the attached photo the top left of the power board there is a cable running to the green board in the middle. The standby voltage should be 5v but is abiut 3v. If i disconnect this cable so the green board isnt connected i have the 5v back. So does this mean the faults in the green board or is it one of those misleqding things that its still in the power board.
Any help would be appreciqted.